Etape 1Pass a M5x20 screw through the top hole of the hinge and fasten it securely using two nuts.
|
Etape 2Using contact cement/glue, fix the parabolic mirror in the center of the hinge.
|
Etape 3Fix together two small slats of wood with two nails to form a "T" shape.
|
Etape 4
Drill a hole at 11.5 cm from the top of the longest slat. Fix the bracket to it with two 3.5 x 16 mm screws (as shown).
Fix the metal "T" ont longest slat with two 3.5 x 16 mm screws. Fix the wooden "T" to it, using a 3.5 x 16 mm screw (Do not tightening it too strong so it can rotate).
Drill 2 holes in the curtain rod and fix it at the end of the long stick with two 3 x 16 mm screws .
|
Etape 5
Report the model of sunglasses on cardboard (according to the model downloadable from the blueprints/plans section).
Cut out the shape for the sunglasses.
Cut the out the holes for the eyes.
Fold in half and place some first-aid metallic blancket in between and glue the two sunglasses parts together.
Cut out the shape for the nose.
Punch 2 holes on the sides and attach an elastic thread.
|
Etape 6
Cut out the mirror cover from thick cardboard (model downloadable in the blueprints/plans section.
Make a hole with an awl where a black dot is drawn.
|
Etape 7
Pass a bolt through the hinge and then through the cardboard mirror cover. Screw a wingnut the other side.
Attach the hinge to the stick by passing a M5x30 bolt through the hinge and the slat. Tighten well on the other side with another wingnut.
|
Etape 8Paint the outside of the truffle cup with high temperature black paint.
|
Etape 9
Fix an M4x25 bolt vertically in the curtain rod usigng two washers and a wingnut (see illustration).
Remove the plastic part of a crocodile clip and pass the clip on the bolt.
|