Réalisation - Parabolic solar Grill
Etape 1
Print twice the model downloaded in from the blueprints/plans section.
Combine the two papers to form the plan.
Report the model as shown on the illustration below, on a large piece of corrugated cardboard.
-Cut with a box cutter the parts shown in yellow.
-Make holes with an awl where green dots are shown
-With a boxcutter, mark the blue lines very genly to ease folding.
Etape 5
To attach the feet, proceed on both sides as follows:
Pass a large washer on a M5 bolt. Then pass it through the inside of one of the grill side.
From outside, pass another large washer. Screw two nuts and tighten them against each other. Add a plastic washer, a wood slat followed by another plastic washer. Tighten the foot with a wingnut.